We designed this breakout board specifically for SPG10 DC brush motor as we know the trouble when you want to solder the wire to tiny terminals rear of the motor, and most of the time it will be tangling around. Soon, the wire will drops from terminal.
We know it is difficult and we want to make it easy for everyone! The breakout will need 1 minute of soldering 🙂 and the terminal is extended out with ready cable/wire. The cable/wire (2 ways) is included, ready with the proper jack for the breakout.
Tiny, compact and useful
Require two points soldering
Mount to the back/rear of SPG10 motor
Center hole allow rear shaft access if there is any.
Ready with JST socket and cable/wire
Additional terminal pads for soldering if cable is not preferred
Robust and easy to use
*There is no User’s Manual as it is quite self explanatory.